Hello all,
I've been redisigning some old highways and hit a "bump". I can't seem to find an Elevated conversion from RHW4 to RHW6. I was creating some off ramps with a turn off lane and the Enter / Exit Ramp 6 type E will exit the highway leaving 2 lanes for through traffic but unless I use an entrance/exit ramp coming from the opposite direction I can't get the highway back to the 4 lane type unless I go to a ground level highway. I'm not sure if I'm missing something or it just cannot be done at the present time.
Thanks.
(https://www.sc4devotion.com/forums/proxy.php?request=http%3A%2F%2Fwww.sherwoods.com%2Fvideo%2Fhighway.jpg&hash=366925179942793f32f90dd82824fd82da13bb21)
These transistions are not in place yet. The current ERHW-6S is actually ment as an overpass only.
As mrtnrln said, none of the ERHWs can transition into each other (Which is very annoying in circumstances like that).
All I can suggest is using another of the ERHW-6C Type D exits and just not connecting the MIS to anything. It'll function roughly like a transition.
I suppose you could connect it to a ERHW4 ramp though.
If you have enough space, you could make an on-slope transition at both ends and have a bit of elevated land to put the transition on, it would work and almost look the same.