(https://lh6.googleusercontent.com/-M9jxIyNz2kQ/UVmQe4LlYNI/AAAAAAAAJW8/vo_WPf1JuIo/s576/1364824164_picsay-1364824164.jpg)
Are there any low density one-way streets available? I am into small towns that looks better to use LD over the higher density road , in addition to wanting to make traffic on some of the streets in the small town square area , trave one way block-over-block.
Sadly, there are no one-way streets, but you can simulate one: At crossroads, you drag a short stretch of oneway road across the intersecting street/road/... and connect these stubs with streets. As cars can't enter these streets in the wrong direction, you get oneway streets in effect.
Quote from: Flatron on May 28, 2013, 04:00:58 AM
Sadly, there are no one-way streets, but you can simulate one: At crossroads, you drag a short stretch of oneway road across the intersecting street/road/... and connect these stubs with streets. As cars can't enter these streets in the wrong direction, you get oneway streets in effect.
Thanks, Flatron, i was hoping there were. And HEY! i've just tried your suggestion after reading your post and IT WORKS! Even better than downloading and installing additional files if there was one.
You're welcome :D
Flatron, good advice.
Rico, while the toned down oneway street did not happen, the idea was not forgotten, as so many have preferred that as an actual NAM component, the production time for it just was not there as of right now.
Quote from: j-dub on May 28, 2013, 04:14:16 PM
Flatron, good advice.
Rico, while the toned down oneway street did not happen, the idea was not forgotten, as so many have preferred that as an actual NAM component, the production time for it just was not there as of right now.
Thanks J-dub! I've wondered for as long as Ive played SC4 why there weren't lo density 1-ways. And now I can still get the effect using Flatron's method. It is good to know that toned down one-ways were part of the design plan.