Can't make the slope mod work fine...

[sandokan]

Hello everybody... I'm posting this because I think the slope mod I've installed isn't working as it's supposed to.
But I'm not very sure about this. I think the slopes I can achieve are too steep (if compared with the ones I've seen so far in this wondrous place for us SC4 devotees...)

I hope anybody could point me if I'm incorrect... I'll post some images to show the situation

(btw, the slope mod I'm using is Jeronij's version of BRF's tunnel and slope mod, and it is loading from my ZZZ's folder into my plugin folder, in case it's important to note)
In addition to this, I have these other mods installed, and loading with BRF's (they load AFTER BRF's tunnel and slope mod):

BridgeHieghtLow&Suspen.dat
Ground Highway Tunnel.dat
Highway Tunnel.dat
Tunnel mod.dat











Are these the slopes I should get with this mod? I'm sure I got better slopes some time ago, but then I've gone into a "download and install" frenzy (this site has such good stuff    )

THANKS for your kindness and for your attention!

SANDOKAN

[RippleJet]

Ground Highway Tunnel.dat
Highway Tunnel.dat
Tunnel mod.dat

You cannot use these three mods together with BRF's slope mod.
They all change the same exemplars and in this case the ones loaded last would disable those loaded first.

Remove those three mods and you should see slopes according to Jeronij's version of the BRF mod.

The BridgeHieghtLow&Suspen.dat only affects bridges and can be used with any of the slope mods.

[sandokan]

Thanks, RippleJet. Your help is always very appreciated! You're most kind !!!

I'm glad to be in this community...

SANDOKAN

PD: I've tried fixing the problem like you said and it works perfectly now...

[RippleJet]

Thanks, RippleJet. Your help is always very appreciated! You're most kind !!!

It's a pleasure helping when I can!
Enjoy the slopes!