Problem with the size of a BAT 1x1 [Problem resolved]

[sauron620]

Hello everybody !

I have a problem in LotEditor because of a BAT. I would like this building to go on a tile. Look at picture:



I have already tried to center the BAT in gmax, but it's always do that. Thank you in advance for your help.

Sorry for my bad in english, I have used an online translation.

[FromTheAshes]

The LODs are much too big. Try to refit the LODs or create custom LODs. It's important to have every part of the model under the LOD, but if the LOD is too big, you get problems like this.
BTW, don't worry about your english, you're doing fine

[sauron620]

Thanks a lot FromTheAshes !  I will try. 

[sauron620]

Uh... A last thing... How can I custom the LODs ?

[Krio]

If you have hard time to speak/understand english, I suggest this board, which is made for French people.

Anyway, you can customize your LODs simply by going to BAT tools-section and then re-lift the LODs from parametres.

[sauron620]

Thank u very much Bengt ! 

[FromTheAshes]

Actually this is not what I was talking about. "Custom" LODs can be created using simple meshes. Just form, deform, whatever the meshes. Then copy twice and rename your 3 new meshes: LOD3, LOD4, LOD5
!BUT!: At this time, don't even think about creating custom LODs. The house is basicly a very simple shape. You're doing better when you simply choose "refit LODs" as Bengt said.

[sauron620]

OK FromTheAshes.  I've done that and it's good !  I can replace the house where I want. Thank you a lot Bengt and FromTheAshes !